Raw water: refers to water that has not been disinfected and filtered, such as river water, stream water, well water, reservoir water, etc.
Feed water: refers to the chemical water delivered from deaerator to boiler by feed pump.
Make-up water: Make-up water for boiler is to make up the lost part or externally supplied part after completing a steam-water cycle, so that the boiler can always operate at a safe water level.
Recycling condensing water: When the heat energy of steam or hot water i...
Water and electricity are not available;
Circulating water pump is not running;
Water flow switch is different;
The 200V 380V power supply is not connected;
The valve is not opened;
The controller switch is set incorrectly;
There is a problem with the controller circuit;
There is something wrong with the programmer;
Leak detection has not been checked;
Air pressure switch impassability;
Air pressure switch 1-3 impassability;
Overtemperature protection and combustion heat protection;...
(1) The furnace drying time depends on the shape, structure and humidity of the furnace. It takes 4 ~ 7 days for small low-pressure boilers and 10 ~ 15 days for heavy furnace walls.
(2) First, bake with wood, on the ash hopper of the room furnace and the grate of the chain furnace, use small fire for natural ventilation within 2 ~ 3 hours. When the temperature of combustion chamber rises, the ventilation capacity will be improved, and the flue damper can be turned down a little. It is best to k...
(1) The boiler and all auxiliary equipment are installed, and all tests such as ball passing test, hydrostatic test and air tightness test are qualified.
(2) All rotating devices, feed water pumps, condensate pumps, salt solution pumps, blowers and induced draft fans for coal conveying, combustion and ash removal are qualified for trial operation.
(3) The fuel and water supply are guaranteed, the steam, water and flue gas piping system are normal, and the connection unrelated to the boiler to ...
Before the boiler is put into operation, the furnace wall and arch must be baked and dried, which is called furnace drying. Furnace drying is to slowly dry the damp furnace wall and arch with warm fire to prevent ignition without furnace drying, causing cracking, deformation and serious damage.
The higher heating value of natural gas refers to the total heat released when a specified amount of natural gas is completely burned, including the latent heat of vaporization released by the condensation of water vapor in flue gas into water.
The lower heating value of natural gas refers to the heat released when a specified amount of gas is completely burned, the temperature of combustion products is the same as the initial temperature of natural gas, and the generated steam remains ...
As a kind of special equipment, industrial boiler is special and complex. Complete inspection can ensure the safety operation of the boiler.
The external inspection of the boiler is generally conducted once a year, the internal inspection is generally conducted once every two years, and the hydrostatic test is generally conducted once every six years.
For boilers that cannot be inspected internally, a water pressure test should be conducted every three years. The internal ...
ATMOSPHERIC BOILER - a boiler in which combustion air/flue gases are drawn through the boiler without a fan. Modulating atmospheric boilers are designed to control the output (size of flame) to match the boilers variable load requirements. During this process the burner is designed to stay at the correct fuel / air ratios across the complete firing range ensuring maximum combustion and boiler efficiencies. Modulation refers to a boiler's ability to match firing rate - input - to meet the heating demand - output - of the system. (https://tlj-eng.com/news/heating-boilers-what-you-need-to-know.html)
