A hot water boiler should be thoroughly inspected at first, including the accessory pipeline. Close the drain valve and open the gauge cock to discharge the air in the boiler.
The installation contents of boiler body pipeline are as follows:
1) Connection between water supply console and economizer header;
2) Connection between economizer and inlet pipe from economizer outlet to drum;
3) Connection between the main pipe and branch pipe of the drum drop and each lower header of the water wall;
4) Connection of steam guide pipe between each water wall header and steam drum;
5) Connection of superheated steam pipe between outlet header of low-temperature superheater...
All boiler pipes have been installed and passed the hydrostatic test.
The furnace wall masonry and insulation work have all ended and has been qualified.
The flue gas duct has been installed and insulated, and the induced draft fan has been installed and debugged to be qualified and can be put into operation.
All the thermal and electrical instruments required for boiler drying have been installed and verified to be qualified.
Mortar samples have been placed on both sides of the middle par...
Boiler feedwater treatment system includes two parts: pre-desalination system and ion exchange desalination system.
The pre-desalination system includes ultrafiltration system, reverse osmosis system, dosing system, chemical cleaning system, compressed air system, etc.
The ion exchange desalination system includes ion exchange system, acid-base regeneration system, compressed air system, wastewater neutralization treatment system, etc.
The boiler feedwater treatment methods ar...
Chain grate has certain selectivity for coal types, and soft coal with volatile content above 15%, ash melting point above 1250℃, moderate particle size and calorific value above 18800~21000kJ/kg is more suitable.
Generally, small gas-fired hot water boilers are between 0.7 MW and 14 MW, and the output of boilers is different, so the prices are different. Different pressures require different techniques, materials and pressures. The higher the pressure, the higher the price.
A 10 tph boiler does not mean that the dead weight of the boiler is 10 tons. The ton of the 10 tph boiler is the heat load unit of the boiler, which is used in engineering, indicating that the rated evaporation capacity of the boiler is 10 t/h.
Because a certain amount of air is usually dissolved in water, with the increase of temperature, the solubility of air decreases, and the gas is gradually separates from the water in the process of water circulation, and gradually gathers together to form large bubbles and even gas columns. Gas is often produced due to the water supplement, so the boiler exhaust valve must be used to avoid damage to the system.
